|
|
 |
|
INSTALLATION INSTRUCTIONS FOR HANGING PANELS:
To download Panelclip® installation instructions, click here:
installation.pdf
Step 1: Measure wall height. Make panels at least 5/8" shorter from ceiling clearance.
Step 2: Snap a level line on all walls to be paneled. See Figure No. 1. NOTE: For 4'-0" x 8'-0" panels, Brooklyn Hardware recommends a
minimum of four lengths of Panelclip® on the wall and twelve 2 1/2" Panelclip® parts on the panel. For panels greater than 8', use additional Panelclip® parts as needed.
Step 3: Using the level line as a reference, mark the location of the bottom edge of the Panelclip® on the wall (B line), making sure that both parts of the Panelclip® will not interfere with the electrical
outlets or plumbing fixtures. See Figure No. 1.
Step 4: Using the appropriate fastener for the type of wall, attach Panelclip® to the wall with the angled surface up and facing the wall. NOTE: Lengths of Panelclip® may need to be shimmed to compensate for wall defects.
Step 5: Make a story pole 3/4" x 1 1/2" by the same height as
the wall. Transfer the Panelclip® bottom edge line (B) to the story pole. Measure up from this line 3 1/6" and mark a parallel line (A). This is the location of the top edge of the Panelclip® on the panel. Also, transfer
the line locating the bottom of the panel. See Figure No. 2.
Step 6: After aligning the panel bottom with the bottom line on the story pole, transfer the A lines to the back of the panel. See Figure No. 3.
Step 7: Align Panelclip® on the A lines on the panel back with the angles surface down and facing the panel. (Brooklyn Hardware recommends 6 pairs –12 parts of Panelclip® per each 4' x 8' panel.) See Figure No. 3.
Step 8: Attach the Panelclip® with the appropriate screw for the panel
material. (Pre-drill if necessary.)
Step 9: Hang panels on the wall and position side-to-side.
Step 10: Pull down with force to wedge the two parts of the Panelclip®
together.
To download Panelclip® installation instructions, click here:
installation.pdf
If you have any questions, please send us an email. |
| |
|
|
|
