INSTALLATION INSTRUCTIONS FOR HANGING PANELS:

To download the trademarked hanging system Panelclip® installation instructions, click here: Installation-page1.pdf  and Installation-page2.pdf

These are the steps as well:

Step 1: Measure wall height. Make panels at least 5/8″ shorter from ceiling clearance.

Step 2: Snap a level line on all walls to be paneled. See Figure No. 1. NOTE: For 4′-0″ x 8′-0″ panels, Brooklyn Hardware recommends a minimum of four lengths of the trademarked hanging system Panelclip® on the wall and twelve 2 1/2″ trademarked hanging system Panelclip® parts on the panel. For panels greater than 8′, use additional trademarked hanging system Panelclip® parts as needed.

Step 3: Using the level line as a reference, mark the location of the bottom edge of the  trademarked hanging system Panelclip® on the wall (B line), making sure that both parts of the trademarked hanging system Panelclip®will not interfere with the electrical outlets or plumbing fixtures. See Figure No. 1.

Step 4: Using the appropriate fastener for the type of wall, attach the trademarked hanging system Panelclip® to the wall with the angled surface up and facing the wall. NOTE: Lengths of the trademarked hanging system  trademarked hanging system Panelclip® may need to be shimmed to compensate for wall defects.

Step 5: Make a story pole (a wood stick) that is 3/4″ x 1 1/2″ by the same height as the wall. Transfer the trademarked hanging system Panelclip® bottom edge line (B) to the story pole. Measure up from this line 3 1/6″ and mark a parallel line (A). This is the location of the top edge of the trademarked hanging system Panelclip® on the panel. Also, transfer the line locating the bottom of the panel. See Figure No. 2.

Step 6: After aligning the panel bottom with the bottom line on the story pole, transfer the A lines to the back of the panel. See Figure No. 3.

Step 7: Align the trademarked hanging system Panelclip® on the A lines on the panel back with the angles surface down and facing the panel. (Brooklyn Hardware recommends 6 pairs  or 12 parts of the trademarked hanging system Panelclip® per each 4′ x 8′ panel.) See Figure No. 3.

Step 8: Attach the  trademarked hanging system Panelclip® with the appropriate screw for the panel material. (Pre-drill if necessary.) As the trademarked hanging system Panelclip® is strong enough to hold product weight, be sure the anchor is also sufficient to sustain the weight of your product. Weight per capacity of anchors chart.

Step 9: Hang panels on the wall and position side-to-side.

Step 10: Pull down with force to wedge the two parts of the  trademarked hanging system Panelclip® together.

To download the trademarked hanging system Panelclip® Classic & Second Edition (SE) installation instructions, click here: installation.pdf

If you have any questions, please send us an email.

Please correct the following:

    *Name:
    Company:
    *Phone Number:
    *Email Address:
    *Street Address:
    *City:
    *State:
    *Zip or Postal Code:
    Product of interest:




    Sizes:
    Length:    
    I'd like to use the products for this application:
    I'd like to get the products by this date:
    Other questions or inquiries:
    Preferred method
    of contact:    		    
    Best contact time:    
     
     
     

    We will respond within 48 hrs. If you need questions answered sooner, please call us at 503-232-1151 or Toll-free 1-888-232-1151. Thank you!